BaseR Container

BaseR-Container

 

Order Form

Standard Features

2 Pin FREE Flap – This flap offers full bridle and pin protection unlike any other BASE rig. This flap tucks into both side flaps and has a tuck tab at the top and a bridle cover at the bottom. With this symmetrical design, you will always have a clean deployment in any orientation. For very short delays, you could even use the flap as a cover without tucking it in.

Magnetic Riser Covers – New to BASE containers, these magnets hold the riser covers closed until they are supposed to open. Bullet proof at terminal in all attitudes, yet open with the greatest of ease. Even with magnets, we still maintained the Narrow Over the Shoulder comfort.

Racer Harness – Without a doubt the most comfortable non articulated harness in the parachuting container industry. Made of single layer type 13, strongest of all webbings, will not slip with any leg hardware. The direct diagonal harness configuration, is pure comfort, especially for the aerialist. Standard with “D” rings and lateral rings to accept a chest mount reserve. These are fully covered until you need to use them when you skydive.

Removable Leg Pads – For ease of cleaning or if you need to replace them. Or for those stealth missions, when you are wearing something over your leg straps. One side has a pull-up pocket and the other has a hook knife pocket. They come nice and wide for good comfort.

Cell Phone / Radio Pockets – Made of spandex, these pockets can hold a cell phone, radio, gum, money or what ever else you might need.

Release Handle / Cut Away Handle

Risers – The risers that come with your BaseR package are standard type 8 risers with Velcro toggles and line release loop. You can order small or large rings, cadmium or stainless. As an option you can order reverse risers for BASE jumping, but we do not recommend them for skydiving.

Quick Grab Toggles – These are Velcro toggles with bungee chord in it to make them easy to grab quickly, yet softer than toggles with cables in them.

Pilot Chutes – Available in 5 sizes; 32”, 36”, 38”, 42”, 46” Available with a standard pvc tube or hackey for the smaller skydiving PC’s. Or a BASE hat handle with or without vents. We use large mesh for the bottom of the PC’s and small mesh for the vents.

Options

Stainless Steel – Everything on the rig becomes stainless except the chest mount reserve attachment rings. These do not come in stainless.

Pinstripes – These are nice highlights on the sidewall or on the back two stripes..

Custom Embroidery – We can do simple names to company logo’s.

Reserve Container – A chest mount pop top, like in the Good Ol Days! Small and lightweight, these containers come in a couple of sizes. It is required to put a TSO’d round reserve in this system.

26′ LoPo Reserve – Probably the most popular round reserve currently being made is the Strong LoPo.